Toa DA-250DH CE-AU User Manual

DUAL POWER AMPLIFIERSDA-250DH CE301DA-250DH CE-GBDA-250DH CE-AUDA-250DDA-250DHThank you for purchasing TOA's Dual Power Amplifier. Please careful

10Connector connectionsStep 1. Loosen the terminal screw, then insert the cable.Step 2. Retighten the terminal screw. (Pull on the cable to ensure it

1110. TAMPER-PROOF CAP ATTACHMENTTo protect the input level control from accidental operation, it is recommended to replace the control knob withthe s

1211. CLEANING THE FILTERStep 1. Turn off this unit's Power switch. Step 2. Remove the ventilation panel as shown in the figure. Step 3. Detach t

13OUTPUT 1relayCH 1OUTPUTCH 2OUTPUT+4 dB-10 dBCH 1 sensitivity selection jumper(+4 dB/-10 dB)CH 1input levelcontrol+4 dB-10 dBCH 2 sensitivity selecti

14220 – 240 V AC, 50/60 HzClass D120 W (based on EN standards)620 W (rated output 4 Ω x 2)400 W (rated output 8 Ω x 2) 2 circuits, +4 dB* (1.23 V, inp

15* 0 dB = 0.775 VNote: The design and specifications are subject to change without notice for improvement. Power cord (2 m) ...

133-22-239-9AURL: http://www.toa.jp/Traceability Information for Europe (EMC directive 2004/108/EC)Manufacturer:TOA Corporation7-2-1, Minatojima Naka

2TABLE OF CONTENTS1. SAFETY PRECAUTIONS ... 32. GENERAL DESCRIPTION ...

3When Installing the Unit• Do not expose the unit to rain or an environmentwhere it may be splashed by water or other liquids,as doing so may result i

4• Avoid installing the unit in humid or dusty locations,in locations exposed to the direct sunlight, near theheaters, or in locations generating soot

54. HANDLING PRECAUTIONS• Keep the input cable away from the output cable. If installed close to each other, oscillation could occur. • To avoid unit

61. Power switch [ ON / OFF]Turning this switch on causes the amplifier tofunction, and turning it off causes the amplifier tocease function.Note: The

7[Rear] 67 9 1011DA-250DDA-250DH867 101186. AC inletConnect the supplied power cord to this inlet.The socket-outlet shall be installed near theequipme

8Step 1. Turn off this unit's Power switch.Step 2. Set the BRIDGE ON/OFF switch (DA-250D only) and CH 1 mode ON/OFF switch.Step 3. Connect the so

97.1.2. When using the DA-250DHCH2 CH1Speaker output terminalsCH1CH1CH2CH2 CH1Speaker output terminalsSwitchCH 1 mode OFFSettingSwitchCH 1 mode ONSe