Toa WM-4300 User Manual download pdf (Page 3)

6. BATTERY INSERTION

Step 1. Holding the microphone body, slide

the battery cover down to open it.

The battery cover is designed not to

be removed from the body.

Step 2. Insert the battery 6LR61 (Alkaline 9 V) according to the instructions

attached to the inside of the battery compartment. Pay attention to

the correct polarity when inserting the battery.

Step 3. Replace the battery cover.

Battery replacement

• A brand-new battery will provide the power enough to operate the unit

continuously for 10 hours.

• As long as the battery has sufficient power for the microphone to function

properly, the orange LED will light. When the orange LED starts to fade and then

flash, replace it with a new one.

Power/Battery lamp

(Orange LED)

7. OPERATION

Step 1. Plug the microphone's plug into the input connector as illustrated.

Step 2. Make sure that the receiver and the wireless microphone are of the

same bank and channel (frequency).

Step 3. If they are not identical in bank and channel (frequency), you have to

adjust the bank and channel switches.

Step 4. Press the microphone ON/OFF switch to turn on the microphone.

The orange LED indicates the circuit is active.

Step 5. Make sure to press the ON/OFF switch to turn off the microphone

again after using.

8. OPERATIONAL HINTS

• The microphone's service distance is 3 – 150 m. When the microphone user moves in a facility, signal

dropouts (momentary losses of signal reception) may be encountered. These dropouts are caused by the

building's architectural designs or materials which block the travel of or reflect the radio signal. If this occurs,

the user needs to change locations for better signal reception.

• The proper operation of your wireless system may be interfered with by other system operating on the same

frequency. In such cases, change the operating frequency of your system. It is recommended that the Scan

function (of the WT-4800) be used to avoid the frequency interference, which always searches and shows

idle frequencies.

• Should you have any questions regarding the use or availability of TOA wireless products, please contact

your local TOA dealer.

9. DISTANCE BETWEEN THE MICROPHONE AND THE MOUTH

Keep your mouth 15 – 20 cm away from the microphone for the best possible sound reproduction. Take care

not to bring your mouth too close to the microphone (within 5 cm) as this impairs speech clarity if you speak

loudly.

10. BANK/CHANNEL NUMBER SETTINGS

Step 1. Slide the battery cover down to open it.

Step 2. Using the supplied screwdriver, set the Bank setting switch

pointer to the desired bank number.

Step 3. Using the supplied screwdriver, set the Channel setting switch

pointer to the desired channel number.

Step 4. Replace the battery cover.

Note

Make sure that the wireless microphone is identical to the wireless tuner in both the bank and channel

numbers. Should the microphone's setting differ from that of the tuner, the tuner does not receive the

microphone signal.

2, 3

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Toa WM-4300 User Manual Page 3

Comments to this Manuals

Related products and manuals for Microphones Toa WM-4300