Toa VM-3000 Series User Manual download pdf (Page 118)

118

[Setting example]

Shown below is a general control input setting screen in the setting software.

The figure shows an example when performing a general broadcast by way of the contact activation.

14.4.2. Using the local input

Local broadcasts can be performed within the area where the unit covers using the VM-3240E's or VM-

3360E's Local input. To use this function, refer to "Local input settings" in "System settings" in the separate

software instruction manual.

Note

This function can be used only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-

3000 Setting Software are 2.00 or later.

VM-3240E/3360E rear

ECH

When using a single-core shielded

cable, connect the shielded mesh to

both E and C terminals.

Local Input

Relation between Control inputs and

broadcast output destinations

AWG 28 – 22

SUB SW2 SW1

Control input

CTRL 1

CTRL 2

CTRL 3

CTRL 4

CTRL 5

CTRL 6

CTRL 7

CTRL 8

Broadcast output

destination

OUTPUT1

OUTPUT2

OUTPUT3

OUTPUT4

OUTPUT5

OUTPUT6

OUTPUT1-6

Not used.

LOCAL

INPUT

Control input

Sound source

input

Broadcast zone

Interlocked control

output

No. 1

VA-INPUT 1

Zone 1

No. 1

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 148 149

Comments to this Manuals

No comments

Toa VM-3000 Series User Manual Page 118

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Toa VM-3000 Series