Toa VM-3000 Series User Manual download pdf (Page 41)

Step 2. The Alert or Evacuation announcement is broadcast over the zone(s) assigned to the Emergency

Control Input terminals. The Emergency indicator flashes red, the buzzer sounds and the Alert or

Evacuation Announcement indicator lights red. At the same time, the Output indicator corresponding

to the set broadcast zone(s) lights.

Step 1. An emergency control signal is input to the Emergency Control Input terminals when an automatic fire

alarm system is activated.

Emergency control input terminals

Note: This figure represents the VM-3240VA/3360VA.

[VM-3240VA/3360VA/3240E/3360E]

Output indicator

Emergency indicator

Alert Announcement indicatorEvacuation

Announcement

indicator

Buzzer

[VM-3240VA/3360VA]

[Emergency control signal entry and operation]

Make settings so that the Alert or Evacuation announcement to be broadcast over the designated zone(s)

when the emergency control input terminal of the VM-3240VA, VM-3360VA, VM-3240E, or VM-3360E is

activated. (For more information, refer to "Emergency Control Input Settings" in "Event Settings" in the

separate software instruction manual.)

6.3. Making Automatic Emergency Announcements Using Control Signal Inputs

(Automatic Fire Alarm Systems, etc.)

This function makes emergency broadcasts by playing back internal Alert or Evacuation announcements

when the emergency control input terminals located on the rear panel of the VM-3240VA, VM-3360VA, VM-

3240E, or VM-3360E receive an emergency control signal from a connected automatic fire alarm system or

external equipment. These emergency announcements being broadcast can also be stopped by the control

signal.

Perform the following settings in advance using the setting software:

Note

Assigning a function to stop the Alert or Evacuation message announcements to the emergency

control input terminals allows these announcements being broadcast to be stopped. This function can

be used only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000

Setting Software are 2.00 or later.

Use the setting software to assign message stop function to the Emergency Control Input terminals.

(Refer to the separate software instruction manual.)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 148 149

No comments

Toa VM-3000 Series User Manual Page 41