7. EQUIPMENT STATUS AND RESPONSE WHEN EMERGENCY MODE IS
ACTIVATED BY EXTERNAL EQUIPMENT
Note
Enable the function for Emergency Activation switch in advance when all the versions of VM-3000VA
firmware, VM-3000E firmware, and VM-3000 Setting Software are 2.00 or later. (For details, refer to
"Emergency Control Input Settings" and "RM-300MF settings" in "Event Settings" in the separate software
instruction manual.)
7.1. RM-300MF Status and Operation When Emergency-Activated by External
Equipment
The Emergency indicator flashes red and the buzzer sounds. If the Emergency Activation switch is pressed,
the Emergency indicator stops flashing and continuously lights red. At the same time, the buzzer stops.
7.2. VM-3240VA or VM-3360VA Status and Operation When Emergency-Activated by
External Equipment
The Emergency indicator flashes red and the buzzer sounds. If the Emergency Activation switch is pressed,
the Emergency indicator stops flashing red and continuously lights red. At the same time, the buzzer stops.
7.3. When Emergency-Activated by External Contact Input from Automatic Fire Alarm
Systems, etc.
•
VM-3360VA or VM-3240VA: The Emergency indicator flashes red and the buzzer sounds.
•
RM-300MF: The Emergency indicator flashes red and the buzzer sounds.
If the Emergency Activation switch of each device is pressed, the Emergency indicator stops flashing red and
continuously lights red. At the same time, the buzzer stops.
Comments to this Manuals