Toa VM-3000 Series User Manual download pdf (Page 99)

RM-200M

Linkage Bracket B

Extension cable

(supplied with the RM-210)

RM-210

Linkage Bracket A

[Bottom]

RM-210 RM-200M

Linkage Bracket A...................................................... 2 (supplied with the RM-210)

Linkage Bracket B...................................................... 1 (supplied with the RM-210)

Tapping screw 3 x 8................................................. 12 (supplied with the RM-210)

Extension cable.......................................................... 1 (supplied with the RM-210)

13.5. Linking the RM-200M with the RM-210 (For Desktop Mounting)

To expand the RM-200M by adding the RM-210 Remote Microphone Extension unit, use the parts supplied

with the RM-210 shown below to link the 2 units.

Complete the DIP switch settings in advance, then follow the procedure below to link both units.

Step 1. Turn over both the RM-200M and the RM-210, and keep them in close contact with each other.

Step 2. Connect the extension cable supplied with the RM-210 between both extension connectors on the

RM-200M’s side and the RM-210’s side.

Step 3. Using the Linkage Bracket B and 4 screws (indicated by arrows in the figure) supplied with the RM-

210, link both units together.

Step 4. Using the 2 Linkage Brackets A and 8 screws (indicated by arrows in the figure) supplied with the RM-

210, fix both units securely.

Note

Use the same steps above when another RM-210 is added.

Notes

• As the Linkage Bracket A has 2 spare

screw holes, use them to link both units if

the designated screw threaded holes are

damaged.

• If incorrect or loose cable connection is

found between both units, remove all the

bracket fixing screws to disassemble the

units and reconnect the cable connection

correctly. Then, link the units again with

the screws.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 148 149

No comments

Toa VM-3000 Series User Manual Page 99